The SolarEdge Sense Connect feature is now supported on Three Phase Commercial Inverters and Three Phase Inverters with Synergy Technology, with DSP1 1.20.xxxx and DSP2 2.20.
Note: SolarEdge recommends upgrading inverter firmware whenever a new version is released Release Notes New Features and Enhancementsįirmware upgrades during site visits is now optional for inverters that were already commissioned and not connected to an Energy Meter.Īfter connecting to the inverter using SetApp, if a new firmware version is available you may decide to delay the upgrade to a later time by tapping Skip Upgrade.
SetApp – Power Optimizer serial number is now displayed on Sense Connect alerts.Log in to the monitoring platform ( using your user name and password. Power Optimizers continuously monitor the connector temperature on their short input and output cables and inform the inverter of any abnormal temperature increase so it can react accordingly Perform Remote Inverter Firmware Upgrade Inverter firmware upgrade is performed per site and should be done for each inverter in that site. Sense Connect functionality is now supported on SolarEdge Three Phase 16K-17K inverters, protecting the PV Module (DC) side of the system.For European countries, the FCR-D-Down capability was added for Three Phase Commercial Inverters with SE DSP.Read this App Note to learn how to toggle the inverter fixed string voltage Make sure that the Plug-in is firmly in place. follow these guidelines: Plug in the Plug-in making sure that all pins are correctly positioned in the Plug-in connector, and no pins are left out of the connector. Relevant for installations connected to the S1200 Commercial Power Optimizer, and only for specific inverter part numbers Locate the Plug-in in its place on the communication board, as shown in Figure 4. Enables improved design flexibility with fewer strings, less cables/fuses and reduced BoS costs all regions outside of Europe and North America), the ability to toggle the inverter fixed string voltage between 750V and 850V is now supported via SetApp for the SE33.3K, SE66.6K and SE100K commercial inverters Sense Connect enhances system safety through early detection and prevention of potential electric arcs at the connector level* due to improper connections or possible malfunctions resulting from wear and tear The SolarEdge Sense Connect feature is now supported on Three Phase Commercial Inverters and Three Phase Inverters with Synergy Technology, with DSP1 1.20.xxxx and DSP2 2.20.xxxx.Note: SolarEdge recommends upgrading inverter firmware whenever a new version is released After connecting to the inverter using SetApp, if a new firmware version is available you may decide to delay the upgrade to a later time by tapping Skip Upgrade. Firmware upgrades during site visits is now optional for inverters that were already commissioned and not connected to an Energy Meter.Three Phase Inverter with Synergy Technology (up to 120kW) with PNs SExxK-xxxxIxxxx Three Phase Inverter with Synergy Technology Three Phase Commercial Inverter with PNs SExxK-xxxxIxxxx Table 2: Inverters' firmware versions Products The CPU version for all SetApp-enabled inverters is 4.17.615. Firmware for SetApp-enabled Three Phase Commercial Inverters and Three Phase Commercial Inverters with Synergy Technology was released in January 2023.įirmware release details are found below.s: